JHM ECU and TCU (Stage 1, Stage 2, Stage 2+ DP) Tuning Combo for Q5 - SQ5 3.0T | JHM-B8Q5SQ5ECUTCU

JH Motorsports is proud to release our JHM B8 Q5-SQ5 ECU and TCU Software!

Our Stage 1 and 2 performance ECU and TCU software is specifically designed to work in harmony together maximize the engine power output capabilities.  With extensive research and testing with our in-house B8 Q5-SQ5 3.0T, we have created the ultimate software for your car. Our tuning will give your Q5-SQ5 3.0T improved throttle response, higher shift points,  and more power throughout the entire RPM range leading to faster acceleration and a much more rewarding and refined driving dynamic.   

This is a one-and-done solution with only ONE Flashing Cable Required (JHM Power-Connect) and can be flashed in the convenience of your own home with an internet connection.

By making an ECU and TCU combination that works together we were able to do the following for your B8 Q5-SQ5 3.0T:

• Engine Rev limit increased to 7400 rpm
• More aggressive throttle control
• Increased shifting speeds
• More assertive shifting in Sport mode and after launching
• Launch Stall RPM raised from ~2000 to ~3000 (outside factors can alter this result)
• More aggressive and consistent Launch
• Refined Drive and normal driving shifting dynamics
• Decreased Transmission wear due to less slipping from faster shifting
• Raised TQ limiters
• Maximum Boost for each Pulley Ratio
• Safe EGT Management for stock catalyst protection keeping your car as safe as possible while maximizing performance
• Free Upgrade from Stage 1 to Stage 2 to Stage 2+ 

Performance: 

STOCK (BONE STOCK CAR) -  We measured the car at 14.17@95.24mph - 2.08s 60ft  - 57F - 91 Octane

JHM STAGE 1 (SOFTWARE ONLY ON STOCK VEHICLE)  - We measured the car at 12.31@111.198mph - 93 Octane

JHM STAGE 2 (Single Pulley)  w/ JHM 187mm Crank Pulley and JHM Silicone Inlet Hose  - We measured the car at 11.96@113.28mph - 93 Octane

JHM STAGE 2+ (Dual Pulley) - COMING SOON

AVAILABLE FILES: 

• Stage 1 - Stock Pullies

• Stage 2 - 179mm Crank Pulley or 57mm Supercharger Pulley  (or other similarly sized pulley options)

• Stage 2+ DP -  207mm Crank Pulley, or Dual Pulley ( 57mm + 187mm combinations or similar)

• Stage 2+ DP w/80mm Throttle Body -  COMING SOON

Available Fuel Options:

• 91 Octane

• 93 Octane

• 100+ Octane (Race Gas) - COMING SOON

• E40 Blend (91 + E85 or 93 + E85 mix) - COMING SOON 

• Water/Methanol specific files - COMING SOON

Customer Supplied Dyno Graph:  402whp and 387wtq

DISCLAIMER: JHM is now using proven flashing technology in order to get our tunes on our customers' cars in the quickest and most convenient way possible. You will be installing a proprietary JHM software that works ONLY with our flash cable (supplemental software such as Microsoft .net may be required). This program is what allows you to detect your ECU part number, fill in your information, select the correct program based on your hardware and then write JHM Tune to your ECU all through your OBD II port. Both of these programs are highly specific when it comes to configuring your computer to run them properly. While every effort has been made to clearly and completely explain this configuration in our instructions, the customer will ultimately be responsible for removing or disabling their own or third party anti-virus software or firewalls that will block the port required for you to log into our flashing server (see the link to our instructions below to determine whether or not this is something you'll be able to do). Basic technical support provided by JHM to help install these programs on your computer, diagnose programs with your computer, and/or internet connection may be subject to an hourly fee. Additionally, if something happens to your ECU during the flashing process, you should be able to restore it using our software. If you are still unable to make the ECU flash properly, you will be responsible for all costs associated with restoring your ECU and fixing the issue.

Requirements for Tune: 
- Windows computer with at least 1 USB (Universal Serial Bus) port 
- Wired Broadband Internet Connection (wireless can be unreliable) 
- JHM Tuning-Flashing Cable (Flash cable length cannot extend beyond 10 ft long unless a powered USB hub is installed in-line. 
- Battery Charger or equivalent power source capable of sustaining a 40 amp charge

⚠️CALIFORNIA WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov